BONANZA X-90 | TRANSONIC RESEARCH AIRFRAME | PHASE 1 EXPERIMENTAL CFG This is an early test envelope, NOT a Mach 0.90-capable finished aircraft. The V3 engine file has been copied UNCHANGED, so its governor settings remain intact. The V3 piston/prop cannot realistically propel a Bonanza to M0.90. Changed in flight_model.cfg: - Raised simulated Mach/IAS ceilings for researching high-speed flight. - Added illustrative increasing compressibility drag through M0.9. - Reduced aerodynamic control authority with higher indicated speed. - Changed reference speeds. These DO NOT deliver additional engine power. NOT INCLUDED: jet propulsion, redesigned wing geometry/3D model, cabin pressurization, working transonic flight certification, custom Mach-limit annunciations. These deliberately require a later airframe/propulsion development and in-sim testing. INSTALL FOR TESTING ONLY: 1) Keep your working V3 backup and save your original flight_model.cfg. 2) Close MSFS. 3) Copy the test flight_model.cfg into the EXACT aircraft folder your V3 uses. 4) Keep your working V3 engines.cfg IN PLACE. Do NOT overwrite it with another engine file unless restoring V3. 5) If MSFS uses a package layout.json, regenerate entries/sizes/dates for edited files with your SDK packaging process or known package layout tool. 6) Test at benign speeds first, then in incremental level-flight steps. Expect unrealistically high load limits and flight-model artifacts. 7) To undo, restore the V3 flight_model.cfg from its existing backup. This prototype's 330-KIAS setting is NOT a real-world safe Vne. The unaltered Bonanza 3D model and structural assumptions do not represent a transonic airframe.