BONANZA X-90 BOOST GAUGE V3 - SEPARATE AIRCRAFT TARGET FIX Why this version: The earlier gauge installers were aimed at the stock bksq-aircraft-bonanzapro package. The separate X-90 installer restored an unmodified cockpit model, so the gauge meshes were absent from the separate aircraft even if you installed the original gauge patch. WHAT THIS PATCH DOES: - Targets ONLY Community/x90-bonanza-experimental - Adds the virtual cockpit gauge panel section under panel.N5172C - Copies the X90Boost HTML gauge assets into the X-90 package - Replaces the separate X-90 interior glTF and matching binary with the prior gauge prototype - Backs up modified files and rebuilds layout.json - DOES NOT change engine, turbo, flight_model.cfg, governor, tanks, or stock Black Square files INSTALL: 1. Close MSFS 2020. 2. Extract the ZIP to a normal folder. 3. Double-click INSTALL_X90_GAUGE_V3.cmd (no Python). 4. Choose the x90-bonanza-experimental folder in Community, not the stock Black Square package. 5. Type INSTALL. 6. Start MSFS and load the separate Bonanza X-90. STATUS: The installer paths and embedded gauge assets have been checked, but this remains an UNTESTED cockpit gauge prototype. A mesh added to an already compiled/optimized MSFS glTF may still require rebuilding through the MSFS SDK. If the gauge does not appear, STOP reapplying position patches. Instead we need an MSFS SDK model rebuild from source or a supported instrument mounted on an existing screen. The location is an estimate and may still be occluded. This change does not alter MAP. ROLLBACK: The installer creates X90_Gauge_Backup_ in the X-90 package folder. With MSFS closed, restore files from the backup preserving their relative paths. Remove the three added files from html_ui/.../x90-bonanza/X90Boost if needed. Rebuild layout.json if removing files; easiest is to restore the backed-up layout.json. Do not point this installer at the stock Black Square package.