◈ X-90T / FLIGHT TEST DIVISION
Phase I-inspired · MSFS 2020 · V1 baseline
NO. X90T-FTB-001 / 16 NOV 2026
Experimental propulsion research · simulator only

Flight Test
Operations Board

A disciplined, task-based test campaign for your 3,000 SHP Black Square Bonanza X-90T. Ground checks before first flight. One variable at a time. Every anomaly earns a log entry.

3,000 SHP configuration targetPT6-derived simulator modelStock propeller in V1MSFS 2020
Campaign progress
0 / 0
0%

Loading cards...

Not yet cleared
Local save status
Simulation scope: This board borrows the discipline of FAA experimental-aircraft testing, but it does not approve real-world flight. The X-90T’s 3,000 SHP engine, raised ITT thresholds and any high-speed airframe claims are fictional. Damage thresholds in the mod are not established continuous operating limits. Do not infer that an uneventful MSFS run validates a physical aircraft.

Flight briefing & test conditions

Record the conditions first. This is what makes flight A comparable to flight B.

Important: Fill in conservative test-day ceilings for ITT, torque, Np, IAS and Mach yourself. Stock printed markings may not match V1’s modified system. We deliberately leave these fields blank rather than inventing approved limits.

Flight data recorder

Test point measurements

Log one stabilized condition per row. Record torque units exactly as displayed. Never treat a percent or normalized display as ft-lb.

0 data points
Engineering notebook

Decision rules & power calculation

GO / HOLD / STOP

GO: previous phase completed, stable turbine and prop, known CG, credible instruments, recorded limits.

HOLD: untested previous card, missing limits, uncertain gauge scaling, unexpected power response.

STOP: governor runaway/hunting, uncommanded control behavior, rising ITT with no stabilization, unexplained fuel exhaustion or reproducible failure. In MSFS, terminate the test point, capture evidence and investigate.

Is 3,000 SHP real in the sim?

If you have actual shaft torque in ft-lb and prop RPM, estimate:

SHP = torque × RPM ÷ 5,252

At 2,200 RPM, 3,000 SHP would require about 7,162 ft-lb. The Black Square torque gauge may use a different scale, so a gauge number alone cannot verify output.

At a nominal 0.42 lb/SHP/hr, the theoretical full-output fuel burn is roughly 188 GPH of Jet-A (using 6.7 lb/US gal), not a guaranteed in-game value.

Source methodology

Based on real flight-test practice

Structured after FAA AC 90-89C, Amateur-Built Aircraft and Ultralight Flight Testing Handbook: planning, airworthiness/weight-and-balance checks, powerplant and propeller checks, taxi, first flight, envelope expansion, and building an aircraft operating handbook from collected data. See also EAA guidance on task-based Phase I testing and USAF/AFRL test-card elements.

This is a tailored simulation checklist, not a reproduction of the FAA 17-task program, certification plan, or a suitable plan for a real 3,000 SHP Bonanza.